KoreMotor frequency

[KimW]

User Question:

I was wondering at what frequency the output PWM of the KoreMotor runs at.

[CaseyK]

I did a little searching through the manual and I was unable to find one stated. There is a way that you can measure this.

Do you have an oscilloscope? If so place a lead on a motor wire. Then set the motor at about 50% and look at the waveform generated. You should be able to measure the frequency that way. If you have any troubles don's hesitate ask! Thanks!

-Casey

[Jonathan]

Thank you for your usefull information.I like this kind of post which tell us much wanderfull massage.

[DanielRich44]

The Set Point value is always use as controller input and Set Point value will directly set the output PWM ratio.may this relation helps you.Otherwise oscilloscope will help you to measure frequency as CaskeyK suggested.